In Heap Leaching technology for mineral processing, large piles of mineralized rocks are irrigated with alkaline or acidic solutions to leach the intended mineral. Generally leach pads are conventional, dumps, valley fills and dynamic on/off pads.

  • Conventional pads are comparatively flat and the ore is stacked in thin layers (Upto to 15 meter).
  • Dumps are similar to conventional pads but the ore is generally uncrushed and very low grade.
  • Valley fills are built in natural valleys with buttress dams at the bottom of valley or a leveling fill within the valley.
  • Dynamic pads are graded to near flat plane since off-loading requires accurate information of the liner system relative to depth

The overburden stress on the liner system is the depth of the ore times the density of ore.

Geocomposite Liner Drainage System


Crushed stone with specific requirements are expensive and not easily available to deliver at jobsite. It is not advantageous to place crushed stone directly against geomembrane. An alternative is necessary which is cost effective and reduce construction time with ease of availability. SKAPS geocomposite, that is TRANSNET geonet bonded to one side or both sides with a nonwoven needle punched geotextiles. TRANSNET geonet made with high density polyethylene does not crush under high normal pressure of ore in heap leach pads. The geotextile act as a filer media and helps smooth, uninterrupted flow. The installation is faster than laying crushed stone and damage to geomembrane is minimum compared to crushed stone layer.

SKAPS Geotextiles in Mining Application


In Heap leaching operation mined ore is usually crushed into small chunks and heaped on a geomembrane and/or clay lined leach pad, where it can be irrigated with a leach solution to dissolve the valuable metals.The crushed ore containing gold is irrigated with a dilute alkaline cyanide solution. Sulfuric acid is used to dissolve copper, nickel and uranium from its ores. So aggressive liquids are used in this process and the geosynthetic materials used in this application have to be chemically resistant across a wide ph range.

A geomembrane liner beneath heap leach stacks provides a primary containment barrier for leach solutions with proper liner selection and installation. Underlying the geomembrane there is a fine grained bedding fill to protect the overlying geomembrane liner from sub grade rock puncture . This layer is not readily available and SKAPS non-woven geotextiles offer a great economical, factory manufactured solution to the problem. SKAPS non-woven geotextiles can be used directly underneath the geomembrane for cushion purposes.

The pregnant solution is collected and transported out of the heap mine using a network of collection pipes. The solution collection pipes survivability and long term flow capacity is often a engineering design problem. SKAPS non-woven geotextiles can be incorporated in the design for filtration function and offer superior solution in comparison to just having gravel in a collection sump or a collection trench.

Cost Comparison


The crushed stone layer costs is about one-third of the total cost of liner system and crushed stone costs have been escalating at significantly higher rate than other construction costs. The gravel is also a problem with cost overruns and project delay. The SKAPS Geocomposite can be used instead of gravel layer partially or completely at a lower cost. It also provides cushion and protects the liner from damage and helps to minimize punctures of the geomembrane.



The SKAPS geocomposite can withstand higher compressive loads, which makes it appropriate to use as a drainage and protection layer under higher loads of large heap leach pads. The SKAPS geocomposite provides better in-plane flow capacity to transport leaching solutions under very high overburden loads.

Please contact us for in plane flow capacity under specific project requirements.